 |
 |
 |
|
|
|
[Sponsors] | ||||
June 9, 2011, 07:39
|
ANSA geometric cleanup
|
#1 |
|
Member
Mohankumar.G
Join Date: Sep 2010
Location: Pune,India
Posts: 43
Rep Power: 5  |
Hi
I am using ANSA software for my geometric clean-up and I just done one tutorial to know the main commands. But I am stuggling to find how to do UNDO operation in this software? How to refresh the geometry because, some times I am unable to see the surfaces which was actually there? Many thanks, Mohan.G |
|
|
|
|
|
June 16, 2011, 10:01
|
|
#2 |
|
Senior Member
Vangelis Skaperdas
Join Date: Mar 2009
Location: Thessaloniki, Greece
Posts: 115
Rep Power: 7 |
Hi Mohan,
Unfortunately there is no UNDO in ANSA, but you can undo most of the operations on your own. For example if you Delete a Face you can Undelete it, if you make a Cut in a Face you can do Join with the right-mouse button and so on. About the refresh of the display you can press Ctrl+F9 hope this helps Best regards Vangelis |
|
|
|
|
|
|
June 16, 2011, 10:11
|
|
#3 |
|
Member
Mohankumar.G
Join Date: Sep 2010
Location: Pune,India
Posts: 43
Rep Power: 5 |
Thank you
Vangelis |
|
|
|
|
|
|
June 16, 2011, 10:22
|
|
#4 |
|
Senior Member
Vangelis Skaperdas
Join Date: Mar 2009
Location: Thessaloniki, Greece
Posts: 115
Rep Power: 7 |
You are welcome,
let me know if you need anything else |
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Using Surface Mesh from ANSA for Fluent Sim | tommymoose | ANSYS Meshing & Geometry | 14 | August 16, 2011 11:20 |
| ANSA to OpenFoam | tH3f0rC3 | OpenFOAM Meshing & Mesh Conversion | 10 | March 15, 2011 06:24 |
| Output deck from ANSA for OpenFOAM use | Kattie | OpenFOAM Meshing & Mesh Conversion | 10 | February 2, 2011 07:46 |
| ANSA mesh in star 4 | alex | CD-adapco | 6 | December 3, 2008 17:30 |
| How to update polyPatchbs localPoints | liu | OpenFOAM Running, Solving & CFD | 6 | December 30, 2005 17:27 |
Linear Mode
