CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Interior surface (http://www.cfd-online.com/Forums/ansys-meshing/100545-interior-surface.html)

Mario22 April 26, 2012 15:19

Interior surface
 
Hi, I'm a student and I'm doing my thesis with ICEM.
I have a 3D mesh and I need to put same interior surfaces in the volume for the post-processing.
The problem is that ICEM doesn't mesh the surfaces, due to this Fluent doesn't recognize them. I tried to fix it in this way:
1) I selected, from the part setup menu, the "int. wall" option for the part of the new surfaces, but it makes error during the meshing with Smooth.
2) From the same menu I selected "split wall", but it makes errors too.
As you can see right now I'm shooting in the dark.
Please help me.
Excuse me for my bad English, I've to improve it...

jeevankumarb April 27, 2012 08:29

HEllo Mario,

Usually if you select internal wall option it will mesh the internal surface. But make sure that there is a material point on either side of the internal surface. If you can post some images it will help in understanding your problem more clearly.

Regards
Jeevan

Mario22 May 2, 2012 13:49

I made a mistake in the creation of the surfaces. The two volume weren't completely separated so ICEM gave error.
Thank you so much for your response.

Goodbye


All times are GMT -4. The time now is 18:49.