[DesignModeler] How remove a profile from another

Hamilton · May 8, 2012, 02:02

Dear friends,
I am a new user in Design modeler, I am going to make a cylinder with a hollow with square cross section in the cylinder, please help me how can I make it ? in fact in the other CAD softwares like solidwork or catia you can do it using "remove" or " groove" how about design modeler ?

Sincerely

Gweher · May 8, 2012, 02:13

Well why not just extruding the sketch of your cylinder already with a hollow square? Even using CAD software like Catia, why doing it in 2 operations if you can do it in 1…

If you still want to do it in 2 operations (creating a cylinder, then “removing” material for the hollow cross section), just create your cylinder, then sketch your square and choose “remove” in the operation option.

May 8, 2012, 02:02	How remove a profile from another	#1
Hamilton Member Alireza Safikhani Join Date: Dec 2010 Posts: 36 Rep Power: 15	Dear friends, I am a new user in Design modeler, I am going to make a cylinder with a hollow with square cross section in the cylinder, please help me how can I make it ? in fact in the other CAD softwares like solidwork or catia you can do it using "remove" or " groove" how about design modeler ? Sincerely

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3D UDF Paraboilc Velocity Profile (Can't Maintain)	Sing	FLUENT	12	August 7, 2017 06:25
How to remove previous profile?	gulogulo	FLUENT	0	November 11, 2011 11:12
Boundary Profile	E61	FLUENT	0	January 5, 2011 08:13
problem with importing and exporting profile BC	Gui	CFX	2	July 26, 2007 08:50
Wind profile	tom	Phoenics	2	September 28, 2005 10:51

May 8, 2012, 02:13		#2
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	Well why not just extruding the sketch of your cylinder already with a hollow square? Even using CAD software like Catia, why doing it in 2 operations if you can do it in 1… If you still want to do it in 2 operations (creating a cylinder, then “removing” material for the hollow cross section), just create your cylinder, then sketch your square and choose “remove” in the operation option.