CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [Other] Swept Tapered Wing (http://www.cfd-online.com/Forums/ansys-meshing/101667-swept-tapered-wing.html)

moonser May 10, 2012 06:40

Swept Tapered Wing
 
Hi guys I know that this is probably a basic question but I am massively struggling here.
I have to create a swept tapered wing in Ansys. I have the 2 airfoils coordinates and generated them in the geometry. I CANNOT seem to join them.

Could anyone shed some light on how I can do this to create a 3-D wing. Any input would be greatly appreciated.

brijeshdubey11 August 17, 2012 15:35

yes you can create a swept wing. just import the co-ord data and by transforming the tip airfoil in the x direction as well as in z dirctn you can see your sweep profile. then join the leading edge and trailing edge points and after that you can create surface.this way you can create swept wing.


All times are GMT -4. The time now is 10:12.