|
[Sponsors] |
May 10, 2012, 06:40 |
Swept Tapered Wing
|
#1 |
New Member
Stephen
Join Date: Feb 2012
Location: London
Posts: 6
Rep Power: 14 |
Hi guys I know that this is probably a basic question but I am massively struggling here.
I have to create a swept tapered wing in Ansys. I have the 2 airfoils coordinates and generated them in the geometry. I CANNOT seem to join them. Could anyone shed some light on how I can do this to create a 3-D wing. Any input would be greatly appreciated. |
|
August 17, 2012, 15:35 |
|
#2 |
New Member
brijesh dubey
Join Date: Nov 2011
Location: new delhi
Posts: 7
Rep Power: 14 |
yes you can create a swept wing. just import the co-ord data and by transforming the tip airfoil in the x direction as well as in z dirctn you can see your sweep profile. then join the leading edge and trailing edge points and after that you can create surface.this way you can create swept wing.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Forward swept wing simulation | abid | Siemens | 1 | June 16, 2012 13:26 |
Swept tapered wing | moonser | CFX | 1 | May 10, 2012 06:37 |
Determing the flowfield on a swept wing | jd88 | Main CFD Forum | 0 | August 26, 2010 14:29 |
[ICEM] Problems about meshing the swept wing with cylinder end cap | kepeng | ANSYS Meshing & Geometry | 3 | June 15, 2010 05:21 |
How to mesh a swept wing in ICEM? | kepeng | ANSYS Meshing & Geometry | 0 | April 24, 2010 12:34 |