|May 16, 2012, 00:36||
Boundary Wrap - Issue
Join Date: Jan 2012
Posts: 100Rep Power: 7
I am trying to make a mesh using TGrid because my geometry is too dirty (impossible to clean and reproducing it takes too long).
TGrid helps me too much but I am facing some issue at surface junctions (figure attached).
My geometry is wing-body type. The problem arises at the wing tails junctions. The mesh is not smooth, boundary is not captured according to the geometry.
I am in a hurry to make its mesh. Any prompt suggestion is highly appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pressure boundary condition issue||Vijay||FLUENT||0||April 6, 2012 13:35|
|mesh file for flow over a circular cylinder||Ardalan||Main CFD Forum||6||April 17, 2010 23:40|
|Import problem||ARC||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||February 27, 2010 11:56|
|Solver error message!!!||IoSa||CFX||1||September 14, 2006 04:48|
|Fluent 5.0 boundary condition issue with RSM||Flav||Main CFD Forum||2||October 20, 1999 04:57|