CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] 2D hole (http://www.cfd-online.com/Forums/ansys-meshing/101891-2d-hole.html)

Feanoro May 16, 2012 11:27

2D hole
 
Hi everyone! I'm new to this forum and to ansys too, so please be patient..
Here's my problem:
I'm designing a 2D geometry made of two squares sharing one side. This side shoud be divided in three segments resulting in two lateral (longer) and one halfway (shorter). This last should be a hole while the other two hard wall, allowing two fluid volumes to be in contact. I can't find how to set a kind of "interior" boundary condition to this segment.
Hoping someone could help thanks a lot...


All times are GMT -4. The time now is 14:59.