 |
 |
 |
|
|
|
[Sponsors] | ||||
May 16, 2012, 11:27
|
2D hole
|
#1 |
|
New Member
Join Date: May 2012
Posts: 1
Rep Power: 0  |
Hi everyone! I'm new to this forum and to ansys too, so please be patient..
Here's my problem: I'm designing a 2D geometry made of two squares sharing one side. This side shoud be divided in three segments resulting in two lateral (longer) and one halfway (shorter). This last should be a hole while the other two hard wall, allowing two fluid volumes to be in contact. I can't find how to set a kind of "interior" boundary condition to this segment. Hoping someone could help thanks a lot... |
|
|
|
|
 |
| Tags |
| 2d model, boundary, design modeler |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing a pipe with a hole | leekj92 | ANSYS Meshing & Geometry | 8 | May 19, 2011 13:34 |
| Cutting a hole in the engine cylinder head in KIVA | CWL | Main CFD Forum | 6 | January 7, 2010 06:37 |
| How to find hole in mesh | prateek jain | CFX | 5 | May 24, 2007 07:06 |
| Cd value....hole in a rectangular tank.... | karthik | FLUENT | 2 | October 29, 2005 13:11 |
| hole in rectangular object... | karthik | FLUENT | 1 | October 5, 2005 09:01 |
Linear Mode
