CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] First layer height - units (http://www.cfd-online.com/Forums/ansys-meshing/101897-first-layer-height-units.html)

saisanthoshm88 May 16, 2012 13:19

First layer height - units
 
Could some one please tell me if the units for the parameters like first layer height (or) total height in the prism mesh set up (or) the spacing in hex meshing are consistent with the units of the mesh

I mean if the mesh is in mm then does a setting of 0.1 for the first layer height also refers to 0.1 mm.

Far May 16, 2012 14:16

Yes, you are thinking correctly.


All times are GMT -4. The time now is 04:42.