CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [Other] Export Geometry in BladeGen (http://www.cfd-online.com/Forums/ansys-meshing/102941-export-geometry-bladegen.html)

strobel June 6, 2012 14:36

Export Geometry in BladeGen
 
I'm quite new in BladeGen and I don't know if here is a right place to post it, but i didnt find any forum specific in BladeGen. So, i made a Turbine in BladeGen and when i export to ICEMCFD or DesignModeler the Solid volume all blades were exported but the volume of fluid is only of one blade. So, how could i export geometry of the volume of fluid of all blades?
Thanks

Vassly June 13, 2012 06:50

Hi, Bladegen cannot create flow zone for all blades, but you can easily do it in design modeller


All times are GMT -4. The time now is 16:18.