CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] Import Sketch/Curves from UG NX8.5 into DM (http://www.cfd-online.com/Forums/ansys-meshing/103357-import-sketch-curves-ug-nx8-5-into-dm.html)

peterputer June 18, 2012 10:23

Import Sketch/Curves from UG NX8.5 into DM
 
Hej,
is it possible to import sketches/curves from UG NX 8.5 in Design Modeler(WB v14)? Atm i m just able to import Parasolid Files,which just consist of bodies but no lines. I d like to ve the sketches directly as sketches in DM if possible so i can use them for parametrization.
Regards


All times are GMT -4. The time now is 02:56.