|June 21, 2012, 09:09||
improving quality of O-grid meshing?
Join Date: Nov 2009
Location: United Kingdom
Posts: 35Rep Power: 8
I would like to know if there is any way I can improve the quality of the cells in the corners of the inner block of the O-grid.
I am creating a mesh with an annular inlet region using O-grid and even though the mesh seems to be ok (pictures 1&2), there are few cells which are very distorted as seen in picture 3 (these cells have determinant 3x3x3 as 0.26 << 0.3).
Is there any way these cells can be smoothed or improved? Is there any other tool in ICEM to generate this type of meshes?
Thank you very much,
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Hex refinement negative quality afterwards||Anorky||ANSYS Meshing & Geometry||8||March 22, 2010 04:25|
|MapFields to New Grid For Extreme Grid Deformations due to Body Motion||albcem||OpenFOAM||0||May 5, 2009 14:17|
|2d irregular grid||Remy||Main CFD Forum||1||December 22, 2008 05:49|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Troubles modelling flow through a grid||Hans Klaufus||CFX||1||June 28, 2000 16:43|