|
[Sponsors] |
[ANSYS Meshing] improving quality of O-grid meshing? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 21, 2012, 10:09 |
improving quality of O-grid meshing?
|
#1 |
Member
Join Date: Nov 2009
Location: United Kingdom
Posts: 35
Rep Power: 16 |
Dear all,
I would like to know if there is any way I can improve the quality of the cells in the corners of the inner block of the O-grid. I am creating a mesh with an annular inlet region using O-grid and even though the mesh seems to be ok (pictures 1&2), there are few cells which are very distorted as seen in picture 3 (these cells have determinant 3x3x3 as 0.26 << 0.3). Is there any way these cells can be smoothed or improved? Is there any other tool in ICEM to generate this type of meshes? Thank you very much, |
|
June 21, 2012, 11:39 |
|
#3 |
Member
Join Date: Nov 2009
Location: United Kingdom
Posts: 35
Rep Power: 16 |
Oh that makes sense... clever!!
Thank you very much!! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hex refinement negative quality afterwards | Anorky | ANSYS Meshing & Geometry | 8 | March 22, 2010 04:25 |
MapFields to New Grid For Extreme Grid Deformations due to Body Motion | albcem | OpenFOAM | 0 | May 5, 2009 15:17 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 05:49 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 12:03 |
Troubles modelling flow through a grid | Hans Klaufus | CFX | 1 | June 28, 2000 17:43 |