|June 22, 2012, 11:16||
ICEM questionhave a simple question.
Join Date: Jun 2011
Posts: 134Rep Power: 6
When I want to export mesh from icme to ansys , it gives this error .(please see the attached file)
what should i do???
thanks in advance.
|June 23, 2012, 14:25||
Join Date: Mar 2009
Location: Ann Arbor, MI
Blog Entries: 1Rep Power: 37
Sorry, not sure. I have never seen that error.
Make sure you have saved your project before hand. Then try again.
It works for me without any issues.
If it still fails for you, please try tech supp @ ansys dot com
|Thread||Thread Starter||Forum||Replies||Last Post|
|Very simple question||Vashishth Patel||CFX||10||November 8, 2011 05:26|
|Conjugate heat transer question - import from ICEM||Catthan||FLUENT||0||November 14, 2010 17:40|
|[TGrid] Simple Question (Simple Answers?): Edge Length adjustment for tet mesh||booz||ANSYS Meshing & Geometry||0||August 29, 2010 12:39|
|CFX-Pre 5.6 text font - A simple question||Pedro Lima||CFX||3||January 22, 2008 11:29|
|A Simple Question||Thomas P. Abraham||Main CFD Forum||3||September 6, 1999 18:19|