 |
 |
 |
|
|
|
[Sponsors] | ||||
March 26, 2018, 10:44
|
Swept Mesh with a Split Face
|
#1 |
|
New Member
Emanuele Spinosa
Join Date: Oct 2014
Location: Manchester, UK
Posts: 26
Rep Power: 11  |
Hi everyone,
I have a very simple ( I guess) problem. I would like to apply a swept mesh to a solid in which one of the face is split, see attached picture. I would like not to modify the geometry as the split face is needed for me to apply a boundary condition for a simulation. How can I get around this and mesh a body with a swept mesh? Thanks you. Regards, E. |
|
|
|
|
|
March 27, 2018, 04:05
|
|
#2 |
|
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 733
Rep Power: 25 |
Extrude the circle through the body to have two sweepable bodies. Put them both in a MultiBody Part to have a node conformal mesh. Choose between the Sweep Method or the MultiZone Method and choose what you prefer.
Last edited by siw; March 27, 2018 at 14:29. Reason: typo |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [simpleFoam] Floating point exception | seuchsy | OpenFOAM Running, Solving & CFD | 3 | November 3, 2016 09:29 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
| [ICEM] Missing face error from FLUENT even after repairing mesh + other questions | unknown159 | ANSYS Meshing & Geometry | 0 | July 5, 2013 20:18 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
