CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Question about mesh generation for a pipe inside a cube (http://www.cfd-online.com/Forums/ansys-meshing/104475-question-about-mesh-generation-pipe-inside-cube.html)

lnk July 10, 2012 12:28

Question about mesh generation for a special case
 
5 Attachment(s)
Hi,

I'm working on the mesh generation for a special case by ICEM. The fluid domain is a pipe inside a cube. And the cube edge is tangential to the circle. I decide to use O-grid. But since the some of the connection part between the pipe and the cube is infinitely small. I always have bad quality over there. Could someone tell me how to solve this problem? :confused:

Best regards and many thanks.
lnk


All times are GMT -4. The time now is 16:30.