[ANSYS Meshing] Meshing for flat plate immersed solid -- CFD Online Discussion Forums

July 10, 2012, 13:32	Meshing for flat plate immersed solid	#1
hamed.majeed Senior Member Hamed Abdul Majeed Join Date: May 2012 Location: New Orleans, LA, US Posts: 147 Rep Power: 13	Hi, I have a problem regarding the meshing of the flat plate as an immersed solid in a fluid domain. The mesh would look like the following. I used Edge sizing and then biasing but still cannot achieve the same results as shown. Any suggestions are much appreciated. Thank you Regards Hamed.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rigid Body State Variables in Solid Immersed Simulation	Hamidreza	CFX	1	October 19, 2009 06:14
Defining Solid Zones Not working	elmcmaster	FLUENT	3	May 22, 2009 07:14
meshing over a flat plate	bhanu kishan	Main CFD Forum	1	February 7, 2009 14:45
Missing tets along line when meshing with ICEM CFD	Georges P. Côté	CFX	6	March 23, 2006 00:34
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09

All times are GMT -4. The time now is 19:55.