|
[Sponsors] |
April 27, 2010, 04:33 |
VAWT 3D meshing in Gambit
|
#1 |
Member
Join Date: Jul 2009
Posts: 43
Rep Power: 16 |
Dear all:
I am using gambit to do the 3D mesh on Vertical axis wind turbine modeling in wind tunnel, however,I have tried lots of way, I still cannot get the good structured mesh on the whole volume. Is there any good suggestion? Thanks a lot |
|
January 16, 2013, 10:12 |
|
#2 |
New Member
maximiliano UAE
Join Date: Dec 2012
Posts: 2
Rep Power: 0 |
Did you solve your problem ? I am doing right now the same problem in 3 D. let me know
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] ANSYS Meshing vs GAMBIT | aerospain | ANSYS Meshing & Geometry | 0 | September 28, 2011 06:05 |
Gambit meshing error | jx | FLUENT | 11 | May 26, 2009 10:35 |
problem with gambit unsymmetrical meshing | meenakshi | FLUENT | 1 | March 28, 2008 12:46 |
meshing a fan using gambit | tony | FLUENT | 1 | February 15, 2008 00:28 |
Gambit: too long meshing time! | delsolman | FLUENT | 1 | January 29, 2008 19:06 |