CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Is there always fault in ICEM tcl scripting? (http://www.cfd-online.com/Forums/ansys-meshing/104744-there-always-fault-icem-tcl-scripting.html)

lnk July 14, 2012 14:37

Is there always fault in ICEM tcl scripting?
 
Hi,

I'm using tcl scripting to parameterize complex geometry. But one bug always happens. I don't know it's mistakes made by me or there's fault from the software. The script worked at the first time. Then I didn't do anything to that script. But when I run it again later, there's error. May I ask if any of you have the same experience at tcl scripting?

Best regards and many thanks,
lnk

Far July 14, 2012 14:55

can you share your script?

lnk July 14, 2012 15:00

Quote:

Originally Posted by Far (Post 371459)
can you share your script?

Sorry, I'm not allowed to share it. Do you have the same experience? I really tried it for a lot of times. The error also changes.

Far July 14, 2012 15:05

I have some experience with ICEM scripting and Tcl as well. I can not really tell you what is the problem with script without looking at it.


All times are GMT -4. The time now is 08:44.