Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

meshing help

Mark Forums Read

Reply

Search this Thread

January 25, 2017, 08:04	meshing help	#1
raunakjung Senior Member raunak jung pandey Join Date: Jun 2016 Posts: 102 Rep Power: 9	\\RJ-PC\Users\RJ\Dropbox\meshI am facing problem while meshing on the curve using ICEM. On the curve I have one vertice. On creating mesh negative volumes are formed on the edge. What could be the possible solution .

Reply

Tags

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] only automatic meshing works,	kazra	ANSYS Meshing & Geometry	2	February 23, 2017 11:38
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 05:09
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[ANSYS Meshing] Icem meshing queries	Mfaizan	ANSYS Meshing & Geometry	21	July 30, 2015 23:10

All times are GMT -4. The time now is 01:37.