|
[Sponsors] |
[ANSYS Meshing] Mesh an edge with a group of points |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 18, 2012, 20:32 |
Mesh an edge with a group of points
|
#1 |
New Member
tl
Join Date: May 2012
Posts: 12
Rep Power: 13 |
Hello all,
I try to use ANSYS mesher creating a mesh going though a group of points with known cooridinates. Can I perform that in ANSYS mesher? How to do that if possible? Thank you in advance! Tianao |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] .STL: non-closed manifold surface | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 32 | November 25, 2016 03:15 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
[Commercial meshers] Star mesh import problem | chris1980 | OpenFOAM Meshing & Mesh Conversion | 20 | May 8, 2006 01:07 |
BFC for Dam break problem | Mehdi BEN ELHADJ | Phoenics | 0 | January 18, 2001 15:22 |