CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Remotely running ICEM with NoMachine NX (http://www.cfd-online.com/Forums/ansys-meshing/105066-remotely-running-icem-nomachine-nx.html)

MarTar July 22, 2012 02:54

Remotely running ICEM with NoMachine NX
 
Hy all,
i am trying to remotely working with ICEM via NoMachine NX but, every time i open a NoMachine session trying to run ICEM, the ICEM process failed.
Someone says this could be caused by the native graphic environment of ICEM.
This is the error i receive from the terminal.

Signal 11 caught!
segmentation violation - exiting after doing an emergency save
X Error of failed request: BadLength (poly request too large or internal Xlib length error)
Major opcode of failed request: 65 (X_PolyLine)
Serial number of failed request: 4477
Current serial number in output stream: 4478

Anyone can help me for resolving this problem?

Thanks in advance!:

MarTar July 23, 2012 02:58

Anyone can help me?

At the moment i have no solution for this problem.


All times are GMT -4. The time now is 03:50.