CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ANSYS Meshing & Geometry

[ANSYS Meshing] Element Type

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   July 23, 2012, 01:17
Default Element Type
  #1
New Member
 
Join Date: Mar 2012
Posts: 27
Rep Power: 5
tomloh is on a distinguished road
Hi all,

I am reasonable new to ANSYS Meshing. I am trying to mesh a 2D nozzle and I would like to change the element type from the default. Does anyone know how to do this? Thanks for any help that anyone can offer.

Tom
tomloh is offline   Reply With Quote

Old   July 23, 2012, 19:02
Default Workbench??
  #2
New Member
 
Diane
Join Date: Jul 2012
Posts: 3
Rep Power: 4
Diane is on a distinguished road
Are you using Workbench, and are you trying to achieve a quadrilateral mesh that follows the edges of the nozzle?

If so, you need to apply mapped face meshing (located under mesh control). Then use sizing and select the opposing sides (inlet and outlet; the two converging sides) to have the same number of divisions (make sure you set the behavior to "hard" so that Workbench doesn't take liberties with the number of divisions you selected).
Diane is offline   Reply With Quote

Old   July 23, 2012, 21:07
Default
  #3
New Member
 
Join Date: Mar 2012
Posts: 27
Rep Power: 5
tomloh is on a distinguished road
Hi Diane,

Thanks for the quick reply, my nozzle is a little more complicated than a straight converging nozzle as it requires some of the geometry form the turbine. I have attached a picture of my geometry. I am wondering how to "size" the curved section (the bottom left of the nozzle). If you have any suggestions I'd greatly appreciate it.

Regards,
Tom
Attached Images
File Type: jpg Untitled.jpg (8.1 KB, 20 views)
tomloh is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Air Conditioned room groovyBC Sebaj OpenFOAM 7 October 31, 2012 15:16
[Other] Mesh Importing Problem cuteapathy ANSYS Meshing & Geometry 1 June 7, 2012 13:39
singularity? mihaipruna OpenFOAM Running, Solving & CFD 5 April 24, 2012 17:18
Pressure instability with rhoSimpleFoam daniel_mills OpenFOAM Running, Solving & CFD 44 February 17, 2011 18:08


All times are GMT -4. The time now is 17:51.