CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Ansys geometry generation via Ansys Workbench (http://www.cfd-online.com/Forums/ansys-meshing/105304-ansys-geometry-generation-via-ansys-workbench.html)

AmandaMBF July 27, 2012 07:49

Ansys geometry generation via Ansys Workbench
 
Good Morning everyone,

I'm trying to do a fluid simulation over an Eppler 423 airfoil using Ansys Workbench - Fluent. I have to open the geometry section, import my airfoil curve and generate the geometry so I can mesh it. I'm following this tutorial https://confluence.cornell.edu/displ...oil+-+Geometry.
I could generate the curve, the surface, the grid and the grid surface. But then I have to create two lines, one horizontal line dividing the grid in half and one vertical line dividing the grid in half. I can create the horizontal line but I cannot create the vertical line. When I try to generate the line by selecting the sketch and generating the curve I have the error: "Boolean operation failed".
Does anybody know how can I fix it?

Thank you


All times are GMT -4. The time now is 09:31.