|August 9, 2012, 09:29||
need to find Linked edge
Join Date: Aug 2012
Posts: 1Rep Power: 0
Hello, I have a very complex blocking done by an ex employee. I am getting negative cells in the pre-mesh.
I found locations, this is due to small height elements near boundary, Now I am trying to increase the height near the Boundary but the spacing 2 is linked to some other edge in the geometry. Is there any way to find the linked edge?
can't find it in GUI (it is not highlighted)
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Bad elements in the narrow gap||saisanthoshm88||ANSYS Meshing & Geometry||6||January 25, 2011 14:22|
|[ICEM] Hole near sharp trailing edge of airplane/wing geometry||jlichtwa||ANSYS Meshing & Geometry||2||September 21, 2010 15:19|
|[ICEM] Changing edge direction||la7low||ANSYS Meshing & Geometry||2||June 7, 2010 13:26|
|How to use Explicit feature edge refinement||ziemowitzima||OpenFOAM Native Meshers: snappyHexMesh and Others||3||April 22, 2010 09:16|
|trailing edge problem||Kuo Wei-Jen||Main CFD Forum||2||April 14, 1999 10:09|