CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] low angle quality at Y-grid (https://www.cfd-online.com/Forums/ansys-meshing/105988-low-angle-quality-y-grid.html)

venkat_aero2007 August 14, 2012 16:19

low angle quality at Y-grid
 
2 Attachment(s)
Hi,
I am meshing propeller blade. I had inserted Y-block at the tip of the propeller blade. In the region of Y-block, i have low angle quality as shown in figure1. Is there any way to improve the angle at the tip of the propeller.

Files can be downloaded form the following link.
https://www.dropbox.com/sh/c6e3l1hh0o1f32a/pxjVod6pAW


All times are GMT -4. The time now is 05:24.