|August 14, 2012, 18:09||
Element "chunks" missing from edge
Join Date: Jan 2012
Posts: 18Rep Power: 4
It's been a few months since I've been on here, but I ran into an issue that I can't seen to resolve alone.
There are elements missing from the smooth trailing edge of one of my turbomachinery blades. It's not a mappable face, and I've tried refining near the edge to regain the elements.
The image, below, [hopefully] shows what I mean by "missing" elements.
|August 15, 2012, 02:28||
Join Date: Jun 2012
Posts: 1,002Rep Power: 17
Does the image show the refined mesh?
If the smooth trailing edge is resolved with only one cell, then the geometry is not well represented, no matter if there are missing cells or not.
Your options are to refine the mesh further or to change the geometry to make it meshable with soch coarse cells.
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to set periodic boundary conditions||Ganesh||FLUENT||13||January 22, 2014 04:11|
|[Other] Mesh Importing Problem||cuteapathy||ANSYS Meshing & Geometry||1||June 7, 2012 13:39|
|errors when installing openfoam2.1 on ubuntu12.o4||hewei||OpenFOAM Installation||5||May 29, 2012 07:43|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 11:55|