CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] [APDL]Create a mesh where KP == NODES (http://www.cfd-online.com/Forums/ansys-meshing/106562-apdl-create-mesh-where-kp-nodes.html)

volaff September 1, 2012 08:57

[APDL]Create a mesh where KP == NODES
 
1 Attachment(s)
Hi friends.
I would like to follow your advice about hardpoints.
To create my mesh I will replace hardpoints with keypoints.

But How do I create a mesh where keypoints == nodes when I will mesh my model???



I have the following problem.

I've attached an image to understand you.:

http://www.mediafire.com/?oz2sd82808k8u85


I have to create a mesh so that kp==nodes.
I have geometry 2D, no volume.

Thanks to all.

abdul Sami September 9, 2012 07:29

meshing problem in ansys
 
Hi every One!

i want to know that in ansys how i create thick mesh near the boundries(in 2d nozzle) and in the centre it should be thin plz help any one plzz

nitinbansal184 September 12, 2012 05:59

Quote:

Originally Posted by abdul Sami (Post 380926)
Hi every One!

i want to know that in ansys how i create thick mesh near the boundries(in 2d nozzle) and in the centre it should be thin plz help any one plzz


You must set mesh parameters by using bunching laws like: exponential2 or exponential 1


All times are GMT -4. The time now is 19:09.