3d elbow
i make my model in gambit is elbow with length 1 meter with more angles between inlet and outlet
each angle is a model i do for 90 , 45, 120,30 it is a circular pipe can any one help me in make this model |
can you post a sketch?
|
http://www.mediafire.com/view/?4n7e16ig2m1b2qthttp://www.mediafire.com/view/?4n7e16ig2m1b2qt
Quote:
seketch ihttp://www.mediafire.com/view/?4n7e16ig2m1b2qts attached http://www.mediafire.com/?4n7e16ig2m1b2qt |
it should help you:
http://www.cfd-online.com/Forums/ans...nd-angles.html |
Quote:
|
create your section (surface), then sweep it along an edge (or edge-chain)
http://www.cfd-online.com/Forums/att...sans-titre.png |
Quote:
point to point |
on the picture links you see what you need: your surface and the curve which will be used to sweep your section.
So first create you section Then create the curves Finally sweep surface with curve |
All times are GMT -4. The time now is 16:11. |