CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Meshing of a eyeball's model (http://www.cfd-online.com/Forums/ansys-meshing/106918-meshing-eyeballs-model.html)

natur3 September 12, 2012 07:23

Meshing of a eyeball's model
 
Hi all!

I had used a lot of points to generate the eyeball model so that i will have higher accuracy of the spline-fitting process.

Will it affect the meshing? Like will it takes a longer time for it to mesh or more difficult to mesh?

Sorry for my bad english and thank you very much.

Best regards,
natur3

PSYMN September 13, 2012 15:00

Are you converting to a bspline or nurb? If so, then no.

If you use it directly as a faceted geometry, then it may slow down the graphics a tiny bit...

Probably not a problem.


All times are GMT -4. The time now is 19:02.