|September 12, 2012, 07:23||
Meshing of a eyeball's model
Join Date: Aug 2012
Posts: 21Rep Power: 5
I had used a lot of points to generate the eyeball model so that i will have higher accuracy of the spline-fitting process.
Will it affect the meshing? Like will it takes a longer time for it to mesh or more difficult to mesh?
Sorry for my bad english and thank you very much.
|September 13, 2012, 15:00||
Retired from CFD Online
Join Date: Mar 2009
Location: Ann Arbor, MI
Blog Entries: 1Rep Power: 38
Are you converting to a bspline or nurb? If so, then no.
If you use it directly as a faceted geometry, then it may slow down the graphics a tiny bit...
Probably not a problem.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Superlinear speedup in OpenFOAM 13||msrinath80||OpenFOAM Running, Solving & CFD||18||March 3, 2015 06:36|
|2D Meshing - No matter how thin my model is, it is still 2 elements thick||RossFS||ANSYS Meshing & Geometry||6||April 14, 2010 00:13|
|Trimmer meshing model STAR-CCM+||rH||CD-adapco||3||December 17, 2008 17:16|
|LES and combustion model||Margherita Cadorin||CFX||0||October 29, 2008 06:24|
|Vehicle CAD Model Meshing||B Bru||CD-adapco||5||June 8, 2007 17:30|