|October 7, 2012, 10:02||
Join Date: Mar 2012
Posts: 4Rep Power: 6
I have a problem with extrude the top of the cyclone. I can not draw a spiral angle (Appendix 1 - so it should look like).
As Annex 2 send drawn by me in DesignModeler the cyclone with the traditional spiral inlet (+ Appendix 3 - jpg).
As Annex 4 I put something about it in a spiral that DesignModeler - but only as lines drawn.
If anyone has any ideas, I would ask for help.
Thanks in advance.
|October 7, 2012, 17:31||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
the only function capable of doing that in designmodeler is the sweep function. if you want the spiral, you need to turn on "twist".
New to ICEM CFD, try this document --> https://goo.gl/NEbygB
|Thread||Thread Starter||Forum||Replies||Last Post|
|Steam-Water Vertical Cyclone Separator||Munggang||FLUENT||3||April 29, 2014 13:38|
|Cannot get the right mesh from gmsh||JinBiao||Open Source Meshers: Gmsh, Netgen, CGNS, ...||2||August 31, 2010 04:51|
|How to extrude 2D Mesh in ICEM CFD?||VSB||CFX||7||December 27, 2006 12:58|
|How to mesh the worm-inlet cyclone||Fuping Qian||FLUENT||0||July 7, 2005 03:59|
|Modelling Industrial cyclone behaviour||GŁnther Hasse||Main CFD Forum||3||October 12, 1999 19:34|