CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Growth ratio with body sizing (http://www.cfd-online.com/Forums/ansys-meshing/108009-growth-ratio-body-sizing.html)

saisanthoshm88 October 11, 2012 19:55

Growth ratio with body sizing
 
When I use a body sizing with a growth rate in ansys meshing for a tet prism mesh I get a uniform mesh in the flow volume and I couldn't see any effect of the growth rate set with the body sizing.

Could some one please explain this.

In case the growth rate doesn't work with a body sizing then I'm thinking of removing the body sizing and instead select all the faces and set a face sizing equal to body sizing.

Can this be a better approach for the growth rate to show up into the volume.

saisanthoshm88 October 12, 2012 07:51

Yes I've tested it and found that the approach of choosing face sizing works better in having the desired growth rate.


All times are GMT -4. The time now is 17:33.