CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] save smoothed mesh (http://www.cfd-online.com/Forums/ansys-meshing/108415-save-smoothed-mesh.html)

m5edr October 23, 2012 05:14

save smoothed mesh
 
Hi All,

I have small inquiry

How to save the mesh after smoothing , if I back to "Display Mesh Quality" I found the old un-smoothed mesh even I save the mesh after smoothing !!

Thanks in advance

m5edr October 24, 2012 03:08

any suggestion

diamondx October 24, 2012 19:32

may be you have prism in your mesh. when you freeze penta-6 to smooth everything else, you get a quality bars. that shows you the quality of all the other elements exept the penta-6. so when you go back to check the quality again, you do that for all the element. It's not comparable. freeze penta-6 in both you will notice that quality bars are same.

m5edr November 1, 2012 11:32

Thanks diamondx for replay

yes , I used "freeze penta-6" option when smoothing the mesh

I appreciated your note :)

thanks again


All times are GMT -4. The time now is 21:24.