CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] Negative value for Enclosure Cushion (

siw November 1, 2012 11:17

Negative value for Enclosure Cushion

I want to make an enclosure around a body to get the fluid volume. However, I need one end of the enclosure to align with one end of the body because the front of the body would make the mesh too large. For example: make an enclosure around an aircraft but starting it along the fuselage behind the nose rather than including the nose and upstream air, forget the fact about needing the upstream air for the CFD.

Any ideas how this can be done since we cannot set cushion values less than 0?


diamondx November 1, 2012 12:44

don't use enclosure, extrude a FROZEN rectangle then and slice...

All times are GMT -4. The time now is 08:43.