[ANSYS Meshing] Automasing the sequential process of meshing different parts

juanmariacg · November 5, 2012, 07:44

Hi everybody,

I am dealing with a CFX aerodynamics simulation. The geometry has two very different zones. I was trying with different methods and configurations and I get the best results of the mesh, meshing the two zones separately: I supress one part and meshing, then unsupress+supress the other part and meshing, and It works very well.

The problem is that I'm doing this process manually and I want to parametrize the model and that is going to required many time.

Is there some way to do this manual process automatically?

thank you very much in advance,

best regards

jrunsten · November 5, 2012, 08:19

Use recording.

Right click Mesh, choose Start Recording, then Start Recording again in the worksheet that pops up. Mesh the different bodies in the order you want and Stop Recording. The next time you mesh it will follow this order.

juanmariacg · November 5, 2012, 08:33

Thank you for your quick response.

I don't have this option, I've found this option is implemented in ansys 14, unfortunaly I have the 13th version yet,

Quote:

Originally Posted by jrunsten

Use recording.

Right click Mesh, choose Start Recording, then Start Recording again in the worksheet that pops up. Mesh the different bodies in the order you want and Stop Recording. The next time you mesh it will follow this order.

November 5, 2012, 07:44	Automasing the sequential process of meshing different parts	#1
juanmariacg New Member Juan Campos Join Date: Oct 2010 Posts: 12 Rep Power: 15	Hi everybody, I am dealing with a CFX aerodynamics simulation. The geometry has two very different zones. I was trying with different methods and configurations and I get the best results of the mesh, meshing the two zones separately: I supress one part and meshing, then unsupress+supress the other part and meshing, and It works very well. The problem is that I'm doing this process manually and I want to parametrize the model and that is going to required many time. Is there some way to do this manual process automatically? thank you very much in advance, best regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
duration of meshing process	stefank	ANSYS Meshing & Geometry	10	November 17, 2015 17:12
[Netgen] meshing process stops (after surf meshing?)	vaina74	OpenFOAM Meshing & Mesh Conversion	5	May 27, 2011 02:32
[ICEM] Problem vt unstructured meshing	raghav	ANSYS Meshing & Geometry	1	October 8, 2010 12:21
[ICEM] Basic meshing doubt	vishnukmd7	ANSYS Meshing & Geometry	2	September 24, 2010 01:36
Meshing 3D AHU room	khimkhim	ANSYS Meshing & Geometry	3	November 4, 2009 11:26

November 5, 2012, 08:19		#2
jrunsten Senior Member Josef Runsten Join Date: Jul 2010 Location: Gothenburg, Sweden Posts: 188 Rep Power: 23	Use recording. Right click Mesh, choose Start Recording, then Start Recording again in the worksheet that pops up. Mesh the different bodies in the order you want and Stop Recording. The next time you mesh it will follow this order.