CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Nodes on Edges... (http://www.cfd-online.com/Forums/ansys-meshing/109639-nodes-edges.html)

RodriguezFatz November 22, 2012 10:26

Nodes on Edges...
 
1 Attachment(s)
Dear All,

In ICEM 14.5, I have a strange error, that I already had some time ago. Last time I fixed it by just remeshing...

When I change the number of nodes on edge "A", one completely different edge "B" (and all its parallels) changes the number of nodes to the same number. Obviously these two edges are not parallel, that's why I am asking. And: Everything worked fine, up to one point - I just changed some linkings and angles... I did nothing with the blocking.

Any idea about the reason?

OK, saving, restarting ICEM and loading exactly the same mesh worked :rolleyes:. Except that now most of my edges have 2 nodes...
Attachment 17127

diamondx November 22, 2012 12:06

funny how all your posts deal with weird behavior. haunted PC i guess !
can you share this project ? if it's not classified, i'm curious in investigating...

RodriguezFatz November 22, 2012 14:02

Quote:

Originally Posted by diamondx (Post 393683)
funny

No.
;)

Unfortunately, after restarting the error vanished, but all edges were set to 2 nodes...


All times are GMT -4. The time now is 16:46.