|
[Sponsors] |
November 22, 2012, 09:26 |
Nodes on Edges...
|
#1 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
Dear All,
In ICEM 14.5, I have a strange error, that I already had some time ago. Last time I fixed it by just remeshing... When I change the number of nodes on edge "A", one completely different edge "B" (and all its parallels) changes the number of nodes to the same number. Obviously these two edges are not parallel, that's why I am asking. And: Everything worked fine, up to one point - I just changed some linkings and angles... I did nothing with the blocking. Any idea about the reason? OK, saving, restarting ICEM and loading exactly the same mesh worked . Except that now most of my edges have 2 nodes... screen.jpg Last edited by RodriguezFatz; November 22, 2012 at 09:39. Reason: picture |
|
November 22, 2012, 11:06 |
|
#2 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
funny how all your posts deal with weird behavior. haunted PC i guess !
can you share this project ? if it's not classified, i'm curious in investigating... |
|
November 22, 2012, 13:02 |
|
#3 |
Senior Member
Philipp
Join Date: Jun 2011
Location: Germany
Posts: 1,297
Rep Power: 26 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Assigning different number of nodes to parallel edges | Rohit | ANSYS Meshing & Geometry | 3 | September 22, 2017 09:16 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |