CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ANSYS Meshing] Help me please!! (http://www.cfd-online.com/Forums/ansys-meshing/109660-help-me-please.html)

jobito_2012 November 23, 2012 02:34

Help me please!!
 
2 Attachment(s)
Hello everyone ... I wanted to ask if I can help me in to do two domains in fluent ... I need to model a flow through a series of tubes (photo), but do not know how to make the internal flow to make the mesh I hope I can help ... thank you in advance ...!


My solid is cooper and my fluid is water


Im sorry for my english...im learning too!

jrunsten November 23, 2012 10:07

In Design Modeler, try Tools > Fill
Choose "By Cavity" and select all the internal surfaces, then generate

jobito_2012 November 23, 2012 12:33

Hi!!
 
Quote:

Originally Posted by jrunsten (Post 393840)
In Design Modeler, try Tools > Fill
Choose "By Cavity" and select all the internal surfaces, then generate



I tried to do it but I can not select all inner faces ... you know how to select all interior faces?...:)

diamondx November 23, 2012 12:51

when you select one inner face, there is a tool that can help you "extend the selection to the limits" without having to select every face

jobito_2012 December 4, 2012 23:26

Hi !!
 
Quote:

Originally Posted by diamondx (Post 393868)
when you select one inner face, there is a tool that can help you "extend the selection to the limits" without having to select every face



mmmm, Thanks for your answer, helped me a lot, but I have a question ... I can not find the command "extend the selection to the limits" , where is that command? ...

Thanks again! :)


do not worry ... I'll find the command!! thank you! :)


All times are GMT -4. The time now is 20:50.