[ICEM] Problem in creating different zones in ICEM-CFD

samurai_01 · November 28, 2012, 04:34

Hi everyone.
I am a beginner in ICEM CFD. my problem is that i have been solving a problem of fluid flow through microchannel in 2D, with three separate region, two of them being solids and the middle one being the fluid region.
As i am meshing in ICEM CFD:
1. i am unable to use blocking on 3 regions as when i select blocking, it selects the entire entity as a single geometry, which i don't want to.

2. i am creating different bodies for my problem but when i right click and dispaly info, it says there are no curves/surfaces/mesh parts in the body parts created. (say fluid / solid1/solid2).
and when i export the mesh, it displays only one single zone(the default GEOM) and not the 3 zones i want to.
I have attached the image of my figure with zone's names specified and
Please help... i have read many posts and have tried and falied, but to no avail.

diamondx · November 28, 2012, 08:48

Use a blocking, after splitting your blocks, right mouse button on part, then create, then click on "blocking material" give the name fluid1 and select the block you want to dissociate from solid...

samurai_01 · November 28, 2012, 12:41

THANK you very much for your precious help..... i am trying it out and will let you know the results...

UPDATE:

yes it worked in my model for 2d and for 3d .... thanks for helping out

November 28, 2012, 08:48		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	Use a blocking, after splitting your blocks, right mouse button on part, then create, then click on "blocking material" give the name fluid1 and select the block you want to dissociate from solid... CFDger likes this. __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

November 28, 2012, 12:41		#3
samurai_01 Member Join Date: Oct 2012 Posts: 46 Rep Power: 13	THANK you very much for your precious help..... i am trying it out and will let you know the results... UPDATE: yes it worked in my model for 2d and for 3d .... thanks for helping out Last edited by samurai_01; November 28, 2012 at 23:35.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Learn ANSYS ICEM CFD	easy_astronaut	ANSYS	2	December 15, 2013 15:34
[ICEM] ICEM CFD boundary conditions conversion to Fluent problem	kalyangoparaju	ANSYS Meshing & Geometry	0	October 30, 2011 23:40
icem cfd ai environment 11.0, laptop keyboard problem, linux	pertupd	Hardware	3	October 3, 2011 08:27
ICEM 12 CFD help creating volume mesh from stl	EmpError	ANSYS	0	November 13, 2010 06:38
ICEM CFD 5.1 problem with tetra count	Baskaran	CFX	2	March 13, 2006 12:59