|
[Sponsors] |
November 28, 2012, 07:35 |
Blocking strategy for ejector
|
#1 |
Member
Andrey
Join Date: Sep 2011
Posts: 86
Rep Power: 16 |
I create O-Grid with selected blocks, delete blocks of pipe wall, then create another O-Grid for inner of small pipe, associate faces with surfaces for internal and external wall surface of a small tube and create O-Grid for big pipe. Any other ideas?
|
|
November 30, 2012, 07:59 |
|
#3 |
Member
Andrey
Join Date: Sep 2011
Posts: 86
Rep Power: 16 |
How to create the O-Grid for big pipe (or it had to be created from the start) and improve the quality (some bad cells)?
|
|
November 30, 2012, 17:48 |
|
#4 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
i tried adding them but it didn't work. i know what it feels like to do it all over again, so i redid the blocking for you without the external tube. What's left to do is extrude one face following the external tube and add another o-grid, sorry about that... other than that, the quality is ok.
Here is my try: https://dl.dropbox.com/u/35161486/ejector_ali.zip |
|
December 3, 2012, 07:50 |
|
#5 |
Member
Andrey
Join Date: Sep 2011
Posts: 86
Rep Power: 16 |
I didn't understand.
1. In your project I only click Pre-Mesh 2. I associate edges to... 3. ... curves. 4. I get the following. |
|
December 3, 2012, 11:11 |
|
#6 |
Senior Member
Christoph
Join Date: May 2011
Location: Germany
Posts: 182
Rep Power: 17 |
i made the outer o-grid. there were some errors like some weird linkings etc....i fixed them.
you've to push some edges to improve quality, but blocking is ok now. http://dl.dropbox.com/u/20868801/ejector.rar |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Helical wire wrapped around cylinder blocking strategy in ICEM | wingcollide | Main CFD Forum | 6 | December 25, 2013 20:32 |
[ICEM] o grid blocking strategy? | icemaniac178 | ANSYS Meshing & Geometry | 14 | March 20, 2013 00:18 |
[ICEM] Blocking strategy for inclined plate | cbisw | ANSYS Meshing & Geometry | 3 | May 27, 2011 09:17 |
[ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 05:46 |
Blocking strategy | Twix | ANSYS Meshing & Geometry | 11 | June 28, 2010 13:09 |