[jobito_2012]

Hello everyone ... I wanted to ask if I can help me in to do two domains in fluent ... I need to model a flow through a series of tubes (photo), but do not know how to make the internal flow to make the mesh I hope I can help ... thank you in advance ...!


My solid is cooper and my fluid is water


Im sorry for my english...im learning too!

[jrunsten]

In Design Modeler, try Tools > Fill
Choose "By Cavity" and select all the internal surfaces, then generate

[jobito_2012]

Originally Posted by jrunsten

In Design Modeler, try Tools > Fill
Choose "By Cavity" and select all the internal surfaces, then generate

I tried to do it but I can not select all inner faces ... you know how to select all interior faces?...

[diamondx]

when you select one inner face, there is a tool that can help you "extend the selection to the limits" without having to select every face

[jobito_2012]

Originally Posted by diamondx

when you select one inner face, there is a tool that can help you "extend the selection to the limits" without having to select every face

mmmm, Thanks for your answer, helped me a lot, but I have a question ... I can not find the command "extend the selection to the limits" , where is that command? ...

Thanks again!


do not worry ... I'll find the command!! thank you!