|
[Sponsors] |
December 4, 2012, 11:33 |
Unable to split Blocks
|
#1 |
New Member
Giuse
Join Date: Jul 2010
Location: Italy
Posts: 21
Rep Power: 15 |
Hi everybody,
I'm new to ICEM and I'm facing my first issues trying to create a hexahedal mesh of a bifurcation (see attached figure). I must say I was quite into Gambit's way of thinking and, maybe, it made me approach not in the ideal way. I know it is possible to use the blocking approach to produce hexadral meshes and I made several tutorials to improve my skills in it. I thought of creating a T shaped block to be associated to my real geometry. To do so I start from the box in the picture and then I try to split it in for parts. When I split the block (in the picture you can see just the horizontal splitting), I got the following message: Split value: 0.609657 so I figured out splitting was done. Unfortunately, no new block edge is visible and if I turned on the blocks in the model tree, only one block (the original one) was still visible. Playing with the visualization paramaters, I noticed that if I turn off Model>Blocking>Blocks>Whole Blocks I will see four blocks, but I still can't select or delete anyone of them. Honeslty, I don't know what's the matter. Probably I'm mistaking something, but what? Thanks so much for your attention Yours sincerly Giuseppe |
|
December 5, 2012, 03:54 |
|
#2 |
New Member
Giuse
Join Date: Jul 2010
Location: Italy
Posts: 21
Rep Power: 15 |
SOLVED!!
I don't know what happened but now I can do it successfully! Thanks a lot anyway! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] fluent3DMeshToFoam | bego | OpenFOAM Meshing & Mesh Conversion | 31 | August 16, 2023 09:04 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
[ICEM] Deleting VORFN blocks in ICEM CFD | Sai Swaroop | ANSYS Meshing & Geometry | 5 | October 18, 2011 10:26 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |