|December 12, 2012, 05:47||
Inflation in multibody part (hexa & tetra)
Join Date: Sep 2011
Location: Brescia, Italy
Posts: 181Rep Power: 5
I have a room and a heating system near a wall: I have split the air in 8 bodies, so I finally have 9 bodies (including the heater, see figure below considering that the first face is a simmetry plane).
Now, I'd like to create inflation on every walls (see the picture of my last mesh without inflation), but I found a lot of difficulties: I tried sweep methods but always an error occured (poor mesh quality) and the mesh failed; I tried even multibody method but it doesn't resolve my problem and in addiction I coudn't be able to use pinch control (and I need it!!).
If i put inflation without specifying the methods it creates the entire mesh with tetra, but I want tetra only in the air near the heating system and hexa in the others in order to reduce the size of the mesh.
PS: I'm using Ansys 13.0
|Thread||Thread Starter||Forum||Replies||Last Post|
|Solution on hexa mesh vs solution on tetra mesh||Chander||CFX||2||December 10, 2011 10:35|
|icem hexa - load different blockings for each part of geometry???||Catthan||ANSYS Meshing & Geometry||2||May 28, 2010 11:27|
|Both Hexa & Tetra to the same Geometry?||Jaloha||CFX||3||April 28, 2008 05:46|
|HELP! TETRA and HEXA boundary||sunlight007||CD-adapco||6||August 6, 2004 06:15|