|
[Sponsors] |
December 17, 2012, 16:42 |
regarding blocking and splitting
|
#1 |
Member
Rajukiran Antham
Join Date: Dec 2012
Location: Sweden
Posts: 41
Rep Power: 13 |
hello everyone
i'm new to icemcfd ,plz help me out how to use index control while splitting the blocks.. looking forward for a reply |
|
December 17, 2012, 18:43 |
|
#3 |
Senior Member
François Grégoire
Join Date: Jan 2010
Location: Canada
Posts: 392
Rep Power: 17 |
Here is an exercise for you to understand the possibilities of index control:
- Open the attached zipped project. - Play with the display of the parts to see what's what. - Let's say you want to associate all the edges in the cube. - To associate the edges to curves contained in the parts CURVES1 to CURVES4, play with the K dimension of the blocking index control. Example: display BLOCKING and CURVES1 and set the index control as shown in the attached picture. - To associate the curves contained in the parts CURVES5 to CURVES8, play with the I dimension of the blocking index control. - You will realize that you can do the edge associations by working in 2D planes sequentially, instead of having your eyes crossed trying to decode a puzzle of 3D edges. |
|
December 18, 2012, 01:15 |
|
#4 |
Member
Rajukiran Antham
Join Date: Dec 2012
Location: Sweden
Posts: 41
Rep Power: 13 |
thanks a lot
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Blocking topology for cruciform fins | siw | ANSYS Meshing & Geometry | 22 | September 6, 2012 05:55 |
[ICEM] Automatic linear interpolation of parameters when splitting blocks | Ivan | ANSYS Meshing & Geometry | 0 | August 14, 2012 08:30 |
[ICEM] Dealing with Singularity..! | JOKER | ANSYS Meshing & Geometry | 15 | November 10, 2010 08:57 |
how to split hex mesh in icem with desired height? | adam2008 | ANSYS Meshing & Geometry | 3 | August 27, 2009 15:59 |
HELP: ICEM blocking and vorfn / orfn | guest7777 | CFX | 4 | November 2, 2007 12:28 |