|
[Sponsors] |
December 20, 2012, 03:54 |
Warning in ANSYS Meshing
|
#1 |
New Member
Join Date: Feb 2012
Posts: 6
Rep Power: 14 |
Hello everybody,
I`m new in ANSYS, when I mesh some geometry in the Ansys Meshing, there is a warning: "Inflation created stairstep mesh at the some locations". What the meaning of this warning? If I use this mesh on Fluent simulation, is there any effect about this warning to the result of simulation? Thank you very much for the reply. |
|
December 20, 2012, 05:37 |
|
#2 |
Senior Member
|
It is a way for the mesher to avoid collision of the mesh lines in for example narrow passages. You can choose layer compression instead of stair stepping if you want, and I think this is the standard if you have Fluent selected in the Solver Preference:
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1.5-dev GCC-4.5.1 | linnemann | OpenFOAM | 22 | November 3, 2010 03:09 |
OF14 compilation error bistreamb is already declared in this scope | rafal | OpenFOAM Installation | 5 | August 26, 2008 11:23 |
[OpenFOAM] Could you please help me | liugx212 | ParaView | 4 | December 22, 2005 16:55 |