 |
 |
 |
|
|
|
[Sponsors] | ||||
March 13, 2017, 13:18
|
Inflation error
|
#1 |
|
New Member
Dhruvism
Join Date: Mar 2017
Posts: 3
Rep Power: 9  |
 Model : NACA0042 Purpose:Meshing NACA airfoil I am getting an inflation error.Please explain this in detail. Is this due to the gap created by incorrect meshing?Or something else? If I were using HyperMesh I would've created 3 nodes on the vertices of that gap and would have created a mesh element, how do I do the same in Ansys? |
|
|
|
|
|
March 13, 2017, 13:22
|
Error Message
|
#2 |
|
New Member
Dhruvism
Join Date: Mar 2017
Posts: 3
Rep Power: 9 |
Full Error Message: Shell Inflation failed , possible due to edge imprinting or connecting the inflation mesh
Association : Project>Model>Geometry>Surface Body Bodies>Surface Body |
|
|
|
|
|
|
March 13, 2017, 13:25
|
Youtube Link
|
#3 |
|
New Member
Dhruvism
Join Date: Mar 2017
Posts: 3
Rep Power: 9 |
I was following this Youtube tutorial https://www.youtube.com/watch?v=AoexYY8EPZA
|
|
|
|
|
|
 |
| Tags |
| airfoil 2d, meshing basics, naca0042 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
Linear Mode
