|
[Sponsors] |
January 3, 2013, 04:08 |
Meshing Problem
|
#1 |
New Member
Join Date: Nov 2011
Posts: 6
Rep Power: 14 |
Hey Folks,
happy new year! I'm making a small gap analysis and therefore i have a part of a circlegeomtry which I tried to block and mesh. I have done a similiar part last year but not with the kind of arc. Normally i would think that there should not be a problem and most of the blocking and meshing did work without any prolbems. (At least it is an easy geometry) But there is a small wall where the mesh does not fit like it should be (See attached files). I have attached also the project file, if the pictures are not meaningful enough. Kind regards John |
|
January 3, 2013, 05:48 |
|
#2 |
New Member
Join Date: Nov 2011
Posts: 6
Rep Power: 14 |
When I started last year with this task it was just not working. But now, after some time to think about it and to get a new perspetciv i found the problem :-).
There was just a edge missing, don't know where it went. I did a new blocking and now it's working. Really annoying if the problem was such a simple one and I did not catch it because the blocking is so unclear. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with querying the meshing database in CFX-Pre | ashtonJ | CFX | 18 | April 18, 2023 23:49 |
[Other] Hex meshing problem DM12 | patrick | ANSYS Meshing & Geometry | 7 | January 9, 2015 07:21 |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 20:03 |
Meshing problem in GAMBIT | Vidya Raja | FLUENT | 0 | May 20, 2006 23:31 |
GAMBIT meshing problem | Gauthier Lambert | Main CFD Forum | 1 | August 3, 2000 09:22 |