CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Icem (http://www.cfd-online.com/Forums/ansys-meshing/111157-icem.html)

davidrlc89 December 29, 2012 13:15

Icem
 
Good afternoon, the meshing in ANSYS ICEM-CFD. in detail mesh, Set Use Automatic Tet Inflation from None to Program Controlled. and I throw these warnings
* Pre-generation layer is stopped inflation Because of side face limitation, proximity collisions and quality.
* Pre-inflation failed with non prism mesh generated, please check the attachments on the faces inflation.
if anyone can help me with this. thanks
if someone could get close to a solution, I'd be grateful.


All times are GMT -4. The time now is 03:29.