|
[Sponsors] |
[ICEM] how to refine mesh along the certerline |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 1, 2013, 09:12 |
how to refine mesh along the certerline
|
#1 |
Senior Member
|
dear frineds:
I want to generate tri mesh in a square cavity. I need the tri element along the center lind of the cavity is very fine. in icemcfd 12, how to set this property. I found the creat density, but it seems it only works for 3d problem. regards |
|
January 1, 2013, 16:41 |
|
#2 |
Super Moderator
|
Create the 3d mesh along with the density box at the desired location and then delete the 3d mesh and shell meshing of other five surfaces. Keep the surface mesh you require.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[Netgen] How to refine mesh? | skovhus | OpenFOAM Meshing & Mesh Conversion | 0 | February 23, 2010 12:30 |